# Dots, subsections in beamer

\section{Results}

\subsection{}

\frame
{
\frametitle{Example 1}
\setbeamercovered{dynamic}

\begin{itemize}
\pause \itemi  example 1 say
\end{itemize}
}

\frame
{
%\frametitle{Example 1}

\begin {figure}[h!]
\centering
\includegraphics[width=6cm]{figureK-Fixed.eps}
\label{figureK-Fixed}
\end{figure}
}


While I do it, the second frame appears as a new dot in the header. How can I make just the first one appear? Can I close a subsection?

-
Please add a minimal working example (MWE) that illustrates your problem. – Werner Nov 28 '11 at 6:11
@Felipe if you explain what you need better I am sure someone will be able to help you. – Vivi Nov 29 '11 at 0:53

Including the OP's code snippet in a working example results in two frames with the same title (if one uncomments the second \frametitle). The first frame contains two slides (a list with one item which is uncovered on the second slide), the second frame contains a graphics. As there are two frames, there are two "dot" entries in the header (assuming, e.g., the miniframes outer theme).

I guess the OP wants one frame with three slides, and the list to be replaced with the graphics on the third slide. This can be achieved using the overprint environment and the \onslide command.

\documentclass{beamer}

\useoutertheme{miniframes}

\begin{document}

\section{Results}

\subsection{}

\begin{frame}{Example 1}

\setbeamercovered{dynamic}

\begin{overprint}

\onslide<1-2>
\begin{itemize}
\item<2>  example 1 say
\end{itemize}

\onslide<3>
\begin{figure}
\centering
\rule{1cm}{1cm}

\end{figure}

\end{overprint}

\end{frame}

\end{document}

-