Take the 2-minute tour ×
TeX - LaTeX Stack Exchange is a question and answer site for users of TeX, LaTeX, ConTeXt, and related typesetting systems. It's 100% free, no registration required.

Possible Duplicate:
How can I make a table that takes up more than a single page?

Is there a way to allow tabular environment to split across two pages? I build an environment which uses tabular, because I want to write something short in the left side, and explanations in the right side. Everything is fine until the table becomes big enough not to fit on the page it started, and then it jumps on the next page, leaving half a page blank before it. Is there a way to avoid this?

share|improve this question

marked as duplicate by lockstep, percusse, Gonzalo Medina, egreg, Paulo Cereda Mar 31 '12 at 22:30

This question has been asked before and already has an answer. If those answers do not fully address your question, please ask a new question.

    
Why don't you try the parallel package? –  Harish Kumar Mar 31 '12 at 17:59

1 Answer 1

up vote 2 down vote accepted

The longtable and supertab packages provide multi page table support.

share|improve this answer
    
supertable did the job. Thank you. –  Beni Bogosel Mar 31 '12 at 19:26
    
ahh. the opposition:-) –  David Carlisle Mar 31 '12 at 19:39
    
Are there things one of them can do better or in which they differ? –  doncherry Mar 31 '12 at 19:49
    
@doncherry: In my document, longtable produced longer tables than supertabular, which was not very good, since I wanted things to be as compact as possible. –  Beni Bogosel Mar 31 '12 at 19:53
    
@DavidCarlisle: perhaps in the last sentence one of the STs should be replaced by LT? ;-) –  Gonzalo Medina Mar 31 '12 at 22:39

Not the answer you're looking for? Browse other questions tagged or ask your own question.