2
votes
1answer
85 views

Convincing pdfbook to assume letterpaper

I have a small booklet in half-letterpaper size: \documentclass{book} \usepackage[paperheight=8.5in,paperwidth=5.5in]{geometry} \usepackage{mwe} \begin{document} \lipsum[1-13] \end{document} But ...
5
votes
0answers
596 views

Figure on A3 page within A4 document

In my dissertation, I got some diagrams that don't fit a single (horizontal) A4 page. Hence I decided to print them on A3 pages that might be unfolded when reading. I followed the instructions in ...
1
vote
0answers
53 views

Print a document with exam class so that it can be folded into a book [duplicate]

Possible Duplicate: Printing a book Is there a method when printing on a5paper with exam class so that it comes out like a book? Folding down the middle, and have it print the pages in ...
8
votes
3answers
290 views

Foldable DIN A0 page within normal document

This question is somewhat similar to this question: Insert foldable A3 pages in an A4 document with active references However it's not completely the same. I want to have a foldable DIN A1/DIN A0 ...
2
votes
1answer
2k views

Selecting fontsize in B5 book

I used \documentclass[twocolumn]{book} \usepackage[top=1.5cm, bottom=1.5cm, left=2cm, right=2cm]{geometry} to make A4 paper size book and then join two A4 pages to one A4 page landscape (that ...
14
votes
1answer
1k views

Rules of thumb for size of binding correction (BCOR)

I was searching for this for a while now and I keep getting referred to an article about binding correction (probably in german) that seems to be offline. Another tip was to measure the horizontal ...