1
vote
0answers
129 views

Circuitikz: connection of nodes [duplicate]

I'm using the circuitikz library to draw some circuits. To connect two nodes with a square angle, there is the possibility to use |-, as in the MWE below for the connection of (a) with (b). However, ...
3
votes
1answer
263 views

Flow of current in a circuit

I am trying to create a circuit with resistors and voltage sources. I need to have each resistor labeled with their resistance (above) and the unknown current (below) flowing through the resistor. I ...
4
votes
1answer
286 views

CircuiTikZ: draw transformer without conductors going to the side

I would like to draw a transformer in CircuiTikZ without the small parts of conductor going to the sides. Left: Current situation. Right: What I want. Code: \documentclass{article} ...
5
votes
1answer
2k views

Circuitikz - IC circuit with relative coordinates

I've represented an IC circuit using circuitikz, but it's a bit too rough to what I prefer. In particular I would like to use relative coordinates in this case and connect them to the ``IC device'' so ...
4
votes
1answer
2k views

Creating custom electronic components in TikZ

In Tikz there is an opportunity to draw logical gates,... I was wondering if it is possible (and easy) to make custom components, like a CMOS-transistor, a Multiplexer, flip-flop,... Perhaps these ...