0
votes
0answers
13 views

Image next to paragraph, start next paragraph below both

In LaTeX, I have a number of short paragraphs, each with a headline and an image on the right side. % First section \spacedlowsmallcaps{Some headline} \begin{floatingfigure}[r]{4.5cm} ...
1
vote
0answers
20 views

Float goes to bottom of page even with forced 'H' placement [duplicate]

I have a certain document with a few tables one after another. Each table is in its own subsubsection. The peculiar thing about these tables is that two tables can fit on a page with a subsubsection ...
1
vote
1answer
38 views

Latex centering figures and tables when alone on a page

I have 4 tables that need to follow each other (they are in the appendix). Two fit on a single page together but there is plenty of space left (thought not enough for another table). I would like to ...
5
votes
2answers
63 views

Figure placed on a separate page is centered and not on top

I have multiple figures placed in my document (all of which are using [htbp], [ht] etc. and are placed correctly). The last figure receives a separate page (which is alright) but it's centered on this ...
7
votes
4answers
112 views

Proper alignment of three boxes

I want two text boxes to appear next to a photo which is 5cm wide. The combined height of the boxes may be greater than or less than the height of the photo. If the combined height is less than the ...
1
vote
0answers
69 views

how to vertical-align a figure

how can I vertical-align a figure? I've tried with: \documentclass[a4paper,10pt]{article} \usepackage[utf8]{inputenc} \usepackage[margin=1in]{geometry} \usepackage{chngcntr} \usepackage{tabularx} ...
1
vote
0answers
19 views

floatingfigure doesn't start at first paragraph after page wrap

A floatingfigure I created is not aligned at the first possible paragraph. It is put directly after subsection. The space on the page does not fit for the figure, so it wraps to the next page (which ...
3
votes
1answer
44 views

Floating parameter [H] streches table vertically

I am currently using [H] as a floating parameter for a list of tables in the appendix. The idea is to make the tables in the appendix start at the same vertical distance from the top on every page ...
3
votes
1answer
96 views

Placing many floating tables

I have written a chapter with many tables (20+) that are all set to 'tbp' for bottom, top and page. There is also text around these tables. The placement of most of the tables turned out to be on top ...
0
votes
0answers
111 views

How to put text between stacks of images?

I need to know how to put text between stacks of images in LaTeX in an elegant way. I have tried to use \par, \linebreak, \bigskip, but the results are not good. Here is the code: \begin{figure}[ht] ...
3
votes
1answer
84 views

Position of figure in a new page

Writing my thesis, I have to put an image in a new page, but it is always in the middle of the page, and I want it on the top. To insert the image I use \begin{figure}[t] \centering \hspace*{-2.0cm} ...
0
votes
1answer
89 views

Not aligned figures!

I have a problem aligning my figures. I am using following code. However, one figure appears a bit higher than the other one. Everything else is perfectly aligned in the paper. Except for these two: ...
1
vote
1answer
87 views

Different heights of elements of subfloat

I am using "subfloat" to visualize both an image and a table inside the same figure as follows: \begin{figure} \centering \subfloat[Summary statistics\label{subfig-1:tab}]{% ...
3
votes
2answers
128 views

Placing a table next to figure (align table vertically centre)

I would like to place a table and figure side by side in my document. I have achieved this with the following code \documentclass[a4paper,10pt]{article} \usepackage{floatrow} \usepackage{color} ...
0
votes
1answer
100 views

Vertical centering of figure

I understand from other posts that a single float should automatically be centered vertically on the page. However this does not seem to be the case in my code. Why? I use the book class. Both ...
4
votes
2answers
140 views

Vertically centering a set of tabbed graphics

I have a lot of different graphics in three versions each. All those versions have a fixed width and I want those three versions to be displayed next to each other. So far, I've used a tabbing ...
3
votes
1answer
319 views

captionsetup inside floatbox messing up image

I'm trying to include images with custom caption label format defined using \DeclareCaptionLabelFormat from caption package. If I put \captionsetup inside \floatbox environment the caption and image ...
2
votes
1answer
196 views

Vertical spacing for two consecutive figure environments

I think I'm not going to solve my problem with the Floats and positioning of figures. I have 4 diagramms and I need to place them on two pages and at the end of the second page the caption for all 4 ...
5
votes
2answers
108 views

Uneven number of subfloats on separate lines

I have 5 subfloats that I would like to distribute 3 on the top line and two udnerneath but equally spaced between the top 3. But \\ doesn't seem to do anything between them. What do you sugges? ...
4
votes
1answer
94 views

How can I take this image on the same line as my text?

Problem I have a sentence in my document that is all on one line. I also have a logo (as a .eps file) that is about the same height as the text. I would like to have the logo on the same line as the ...
1
vote
0answers
37 views

Why does \begin{figure} center my image vertically? [duplicate]

If I insert image into my document as such: \includegraphics{spss24fore.png} The image is aligned at top of the page, but when I use: \begin{figure} \includegraphics{spss24fore.png} ...
4
votes
1answer
180 views

Vertically center a float in the remaining part of a page

How do I vertically center a table in the remaining part of a page? Specifically, I want to put a large table on a single page but I also want to have a subsection title line at the top. However, ...
6
votes
1answer
311 views

Figure and text vertical alignment in two column document

I am trying to set a layout for a twocolumn book with a particular page layout (specified with the geometry package) and with the text in both columns aligned to each other. For this I've already ...
0
votes
1answer
113 views

Aligning subfigures with the plots starting at the same level

I have two figures that I am trying to align side by side. The difficulty is trying to get the two plots on a same horizontal line. In the bad example picture shown below the problem is that the ...
4
votes
2answers
2k views

Figure and table side by side with common caption

I'm not a LaTeX expert, and I want to align a table and a figure side by side, with a common caption; the table and the figure should be aligned to the bottom, too. I tried this: \begin{figure} ...
4
votes
1answer
270 views

Vertically align table in a page

I would try to align vertically a table in a page. I have a page contains only a table and I would put it at the center of the page. To center it horizontally I used \centering but what command should ...
3
votes
0answers
250 views

Uneven columns in two-column paper format [closed]

I am writing a paper in two-column format. I avoid using the multicol package as I deal with quite a bit of within-column figures and would rather have them float. However, I am facing a problem that ...
8
votes
1answer
919 views

Vertical Centering in a multicols

In a document I have several multicols units, in which on one side there is an image and on the other side some information in a itemize. Now, depending on the image / information, the two "sections" ...
4
votes
1answer
353 views

Spacing in multicols environment with figures

I have the following lines: \documentclass[a4paper,landscape,12pt,oneside]{scrbook} \usepackage[english]{babel} \usepackage{multicol,lipsum} \usepackage[demo]{graphicx} \usepackage[utf8]{inputenc} ...
3
votes
3answers
995 views

Vertically align cell table in figure

I have the following figure: \begin{figure}[ht!] \centering \begin{tabular}{|c|c|} \includegraphics{combo} & \includegraphics{combomenu} \end{tabular} \caption{A combo box ...
8
votes
2answers
7k views

Include centered full page figure with no margins

I have a big figure that takes up a full page. I'd like to include it in my latex document on a separate page, centered horizontally and vertically. I managed to put it on a separate page (or it is ...
18
votes
1answer
332 views

Flushbottom columns when \parskip has no stretchable glue

In the following example, the columns on page 1 and 3 "sit" perfectly on the frame, while on page 2 (with the large float) the columns end a bit above the frame. Does anyone have an idea what I could ...
11
votes
2answers
413 views

Center and yet align figures on opposite pages

This is an extension of the question "How to ensure that 2 couples of figures are on 2 facing pages?". I not only want to ensure that the figures are on facing pages but also that the one with the ...
2
votes
2answers
2k views

Center table on landscape page

I have a rather wide table for which I have a designated page in landscape mode. The rest of the document is in portrait mode. Currently, the first row of the table begins at the very top of the page ...
7
votes
4answers
5k views

Placing Subfigures vertically

I want to use subfigures to place three figures like this: The following is the code I used: \begin{figure} \begin{tabular}{|c|c|} \hline \multirow{2}{*}{ ...
5
votes
1answer
647 views

twoside introduces incorrect linespacing at end of section

I have: \documentclass[a4paper,11pt]{report} with no special customisation. In one page, at the end of a section, I have a big figure with two paragraphs of text below it, and these two paragraphs ...
5
votes
0answers
50 views

Why are float objects centered vertically on new pages? [duplicate]

Possible Duplicate: Automatic vertical alignment of a single float on a dedicated page Why are float objects centered vertically on new pages if they don't fit on the page where they are ...
10
votes
1answer
467 views

Context: Placing float (figure) and text-top at same height

I would like my figures to be flush with the text line beside them if they are positioned left or right and top. Currently the top edge of the figures are roughly flush with the 2nd line. This seems ...
6
votes
2answers
689 views

Spacing between figures and texts

I'm having some issues dealing with figures. It happens that when I have a page with some text and then it comes a figure, with H property, who doesn't fits into the same page as the text, the text ...
7
votes
1answer
2k views

vertically align different size images in a figure* environment

I have an figure* environment with the following \begin{figure*} \centerline { \subfloat[1]{...} \subfloat[2]{...} } \end{figure*} The images are different heights. How can I ...
10
votes
2answers
3k views

Two figures side-by-side with inequal height and aligned captions

I have an addition to this question: Two figures side by side. Suppose we have two pictures, making them of uneven height. I am looking for a way to not use subfig and align two figures side-by-side, ...
3
votes
1answer
2k views

Vertical alignment with floatrow

I am playing with floatrow, however the images are not aligned at the top and I do not know what I am doing wrong. \begin{figure}[H] \begin{floatrow} \floatbox{figure}[0.4\textwidth][\FBheight][t] ...
3
votes
3answers
6k views

Figure and table side-by-side in subfloats

A very similar question has been asked before: Table and Figure side-by-side with independent captions I'm trying to accomplish this, but while using the subfig package. The image below depicts ...
9
votes
2answers
5k views

Vertical centering of figure in landscape environment

I am using the pdflscape package to insert landscape pages in my document. On one of these I would like to have a figure that is vertically centered on the page, but I can't find how to do it. MWE: ...
6
votes
2answers
4k views

Automatic vertical alignment of a single float on a dedicated page

In my large latex document, I have some figures which take a considerable height of the page (80-95%). Latex puts each of these figures alone on a page, aligned on top. I would like to have each ...
1
vote
1answer
324 views

newlfm - addrfrom and addrto on the same vertical height

Is there a way to put addrfrom and addrto on the same vertical height when one of them is left-justified and another is aligned to the right? This is basically the layout I'm trying to achieve: ...
4
votes
1answer
404 views

Want figure height to ignore side caption height

I use beside captions placed in a large margin area. Sometimes, the caption text is taller than the figure and this causes too much vertical space around the figure. I'd like the effective height of ...
3
votes
2answers
673 views

aligning bottom of two tables

I need to align the bottom of these two tables, and I need to add a brace to each side of the second table.. how can I do that? \begin{figure}[] \centering \subfloat[]{ \begin{tabular}{cc} ...
9
votes
3answers
1k views

Tables do not align side by side

. . \usepackage{tabularx} \usepackage{multicol} \begin{table}[ht] \begin{minipage}[b]{0.5\linewidth}%\centering \begin{tabular}{|c|c|c|c|} \hline & One & Twp & Three \\ ...
15
votes
4answers
23k views

Reduce space between enumerated items

Background A book with lots of images. All of the images are set to "here definitely" (as they must come after the text that introduces them). Problem The list types (enumerated and bullet) have ...