3
votes
1answer
53 views

How can I arrange the table and the image in a minipage vertically?

I need the table and the image arranged vertically in the minipage instead of horizontally. I also add the pictures used in the code in the end. \documentclass[12pt,a4paper]{article} ...
6
votes
2answers
104 views

Remove padding in table with images

I have a table with 2 small images in each cell. I reduced the horisontal padding with \setlength{\tabcolsep}{0pt} But I still have a white vertical space between a table separation line and images ...
7
votes
2answers
97 views

How to place an image in a chapter title (perfectly centered)

Before to begin, I know about: \chapter{My Chapter Title\hfill\includegraphics{image}} But it's not what I'm searching. I want the following result: Next are all the methods I tried (and their ...
3
votes
2answers
54 views

Unexpected behavior of arraystretch and figures in table cell

Using the graphicx and the includegraphics command, I want to place a figure in a table cell. In addition, I use the arraystretch command the increase the padding of cells. Unfortunately, I get a ...
5
votes
1answer
44 views

Align top of images using subcaption

I'm trying to align the tops of two images using the subfigure environment from the subcaption package. Unless I'm misinterpreting the other questions, I believe I have read multiple questions asking ...
2
votes
1answer
41 views

Alignment of images in \minipage environment

I have a problem with \minipage alignment: I want to place two images side by side with a top alignment, so I used this code: \begin{figure}[!h] \begin{minipage}[t]{0.5\linewidth} ...
3
votes
2answers
176 views

.jpg image inserted in a column is shrinked or squeezed

When I am trying to insert a .jpg image in one column of a table in latex. it is getting shrunk and not able to stretch or fit into the whole column. it is getting shrunk or squeezed & when I am ...
3
votes
2answers
46 views

How to center image in 2 column tabular when one side is Verbatim?

I am having hard time finding the correct way to typeset this: I need to have code as verbatim on one side of the page, and show the output (an image) on the right side of the page. I have tried ...
1
vote
0answers
73 views

how to vertical-align a figure

how can I vertical-align a figure? I've tried with: \documentclass[a4paper,10pt]{article} \usepackage[utf8]{inputenc} \usepackage[margin=1in]{geometry} \usepackage{chngcntr} \usepackage{tabularx} ...
5
votes
2answers
157 views

Images stacked horizontally : unwanted vertical gap

I am trying to stack three images horizontally. The images have the same size, I want to align them without any vertical gap. I followed the instructions that I found on this answer: \blindtext ...
2
votes
3answers
112 views

Minipages' vertical alignment

I use three minipages so to make a table and two images be placed next to each other and although the images are in the right place the table is placed much lower producing an ugly result. Why is ...
3
votes
1answer
42 views

How to align enumerate and image [duplicate]

I have the following code which doesn't align a) and b) with the top of the image. How can I align them? ... \begin{enumerate} \item Find the unknown values and in each case, give a reason. ...
5
votes
2answers
113 views

Aligning two pictures without subcaptions to the top with the subcaption package

My problem is similar to this one: Align by the top borders of figures when using subcaption I want to align two pictures to the top. The solution given works fine for pictures with subcaptions. ...
1
vote
2answers
120 views

rotated text and figure side with vertical alignment

I am using subfig package to place three figures and a one rotated text side by side. Attached below is the mwe \documentclass[draft]{article} \usepackage{subfig} \usepackage[demo]{graphicx} ...
3
votes
1answer
88 views

vertically center to text height

Minimal working example: \documentclass{scrartcl} \usepackage{fontspec} \setmainfont{Linux Libertine O} \usepackage{graphicx} \usepackage{tikz} % correct spelling and hyphenation ...
0
votes
0answers
114 views

How to put text between stacks of images? [duplicate]

I need to know how to put text between stacks of images in LaTeX in an elegant way. I have tried to use \par, \linebreak, \bigskip, but the results are not good. Here is the code: \begin{figure}[ht] ...
2
votes
1answer
2k views

Centre an image, ignoring margins

I have a document with .5cm margins; I want to include a long image which will span the width of the page, ignoring margins. I don't care about the whole image being visible (or which part of the ...
2
votes
1answer
191 views

Vertical Alignment of (graphic+text, inside a mini page)+item number

I have a figure and text inside a minipage inside an enumerate. I would like align the text and the item number and top-align the figure and the text. Top top-align figures and text in the past I ...
3
votes
1answer
84 views

Position of figure in a new page

Writing my thesis, I have to put an image in a new page, but it is always in the middle of the page, and I want it on the top. To insert the image I use \begin{figure}[t] \centering \hspace*{-2.0cm} ...
2
votes
1answer
50 views

Figure keeping vertically

I have a large figure (more width than height) to place vertically (rotate the figure 90 degree anti clockways direction to the way we used to place the fig in latex) to use maximum space of the page. ...
8
votes
2answers
165 views

Included graphics with text: Alignment

tl;dr How do I align text to text within \included graphics? Let's look at the following logo, which I want to include (in a vector format, e.g. pdf or svg). The blue/red lines are my annotations. ...
1
vote
1answer
694 views

Beamer: How to place graphics at the bottom of a frame

I want to achieve that included graphics are always on the bottom of the frame, so that their position isn't influenced by the length of the text above. I tried the figure enviroment without success ...
7
votes
3answers
238 views

Vertically center image with text midpoint

I want to vertically align the center of an image with the vertical center of the text on the same line using \raisebox. Using a macro is a must since it will be used many times (and multiple times on ...
4
votes
2answers
141 views

Vertically centering a set of tabbed graphics

I have a lot of different graphics in three versions each. All those versions have a fixed width and I want those three versions to be displayed next to each other. So far, I've used a tabbing ...
5
votes
3answers
320 views

Vertical alignment of graphic and tabular

There are a bunch of related questions here. But I was not yet able to pull this off yet. I have the following code: (where hist.tex is a plot drawing) \fbox{\scalebox{0.40} {\input{hist.tex}}} ...
3
votes
2answers
119 views

How to start text and image on the same baseline

I need text and images to start at the same level on each page. With standard LaTeX settings the image seems to start a few points higher then a text. I believe this is due to \topskip. \topskip=0pt ...
4
votes
3answers
297 views

How to top align text and image in table?

I am facing some problem in aligning (top-aligned) image and text in a table. \documentclass[11pt,table,a4paper]{article} \usepackage{array,ragged2e} \usepackage{graphicx} \usepackage[top=2cm, ...
2
votes
2answers
91 views

How to align an image to the bottom inside a table cell

I created the following document: Code: \documentclass[11pt]{article} \usepackage[a5paper]{geometry} \usepackage{tabularx} \usepackage{graphicx} \begin{document} \begin{tabularx}{\textwidth}{|X|} ...
2
votes
1answer
97 views

vertical placement of graphics in marginpar

I'd like to put small graphics into the margin via \marginpar. The top of the figures shall be aligned to the top of the text line they refer to. I found around here the suggestion to put a \vskip0pt ...
8
votes
3answers
6k views

Alignment of \includegraphics in a tabular

When putting a graphics inside a table, the text at the right is too much at the bottom Minimum example : \documentclass{article}[12pt] \usepackage{graphicx} % This is already loaded by the ...
6
votes
3answers
3k views

Vertically aligning images in beamer

I have a sequence of images I would like to animate in beamer. In each frame, I would like to have two images, say A and B, aligned vertically and centred on the page. All images are the same size. ...
13
votes
3answers
7k views

Make two figures aligned at top

I am inserting two graphs (of different size) in the following way: \begin{figure}[H] \begin{center} \includegraphics[scale=0.5]{graph1.eps} \includegraphics[scale=0.3]{graph2.eps} ...
2
votes
1answer
292 views

How can I place an image in a marginpar and make it position itself according to the top of the image

As demonstrated by the following MWE, I've placed a simple image in the margin of a document. What appears to happen is the caption text is vertically aligned with the line that I type the \marginpar ...
1
vote
1answer
89 views

How do I have the list item appear on the top left of the image? [duplicate]

I am including an image with the graphicx package in an enumerated list. \begin{enumerate} \item \includegraphics[width=100px]{my_image.png} \end{enumerate} The list item number appears on the ...
4
votes
1answer
627 views

vertical aligning images in table with \adjustbox only works when not every image is in an \adjustbox

I'm trying to center all images vertically and horizontally within a table cell. Therefore I'm using the adjustbox packet. This is the code I use for my table: \begin{table}[b] \begin{center} ...
2
votes
1answer
149 views

Removing space after a graphic

I have the following code and inputted a graphic at some point. When I compile the code, there is a huge white space after the graphic and before the text after the graphic. How do I reduce this white ...
9
votes
2answers
8k views

Include centered full page figure with no margins

I have a big figure that takes up a full page. I'd like to include it in my latex document on a separate page, centered horizontally and vertically. I managed to put it on a separate page (or it is ...
5
votes
1answer
1k views

Center image in landscape mode

I've used the \usepackage{pdflscape} instruction and the following code for inserting an image in a landscape oriented page. \begin{landscape} \begin{figure}[p!] \centering ...
6
votes
2answers
1k views

beamer: How to align images in separate columns?

Here is a snippet of a beamer frame which is divided in three top-aligned columns. Each column contains: some top text an image some bottom text The problem is: because "some top text" in ...
1
vote
0answers
102 views

Safeguard against image alignments [closed]

Images in dictionary appear under the headword. I would like to control the behaviour of the placing with few rules. Controling of the placement should prevent undesired alignment that causes for ...
4
votes
1answer
96 views

Difficulty with lineup of inner table inside a table cell

I need to create a table with 1 row and 2 columns where the first cell has an inner table and the second a photo where I specify the width and let the system take care of the height. My difficulty is ...
1
vote
1answer
257 views

How to put tikzpicture aligned with the footerline?

I would like to put a tikzpicture near the footer line. The tikzpicture is used to show the page number on top of an image. The problem i am having is the tikzpicture is centered on the footer. ...
7
votes
3answers
11k views

How to vertically align 3 images with subfigure?

This code: \begin{figure*}[t] \begin{center} \begin{subfigure}[a]{0.3\textwidth} \label{im:device_front} \includegraphics[width=\textwidth]{images/bsn_side} ...
1
vote
1answer
469 views

Prevent vertical distribution of paragraphs over entire page

It seems it tries to fill an entire A4, as the image of the next page is too big. So it puts a lot of space between the paragraphs. But, I'd much rather have a big chunk of white at the bottom of the ...
4
votes
2answers
1k views

Two images are not on the same level

I am using the following code to put two figures next to each other (I am not providing a minimal example right away, because maybe the problem is obvious from the code. However, I will, if someone ...
4
votes
0answers
101 views

How to push image at the bottom of the present slide? [duplicate]

Possible Duplicate: Beamerposter… Columns not all aligned at top I have made two columns in a beamer presentation slide and both of them contain image. \begin{frame} ...
2
votes
2answers
4k views

Problem with image position on an empty page [duplicate]

Possible Duplicate: Table in LaTeX appearing in middle of next page I'm triying to make an image appear on top, but only works if I have some text, otherwise, the image appears at the ...
0
votes
1answer
4k views

Image shift / offset

I'm writing text with some custom images (symbols) in the text line, I add them using \includegraphics, but the images align with the text at the bottom, which is annoying, since the images are ...
8
votes
2answers
6k views

Fix vertical alignment in beamer

I am using a beamer frame in which the top has alternating list items, and the bottom has a picture. The problem is that because of the different number of rows for each item, the picture changes ...
4
votes
1answer
448 views

Spacing using minipage in theorem environment (ntheorem)

Consider the following example and notice the different vertical spacings between the theorem caption and the text. Is there a way to get the same spacing when using minipage as in the case of normal ...