I have used the package nomencl
. In my code I have incorporated the \nomenclature
as well. But when I compile, it is not showing me any results. My code is :
\documentclass[pdftex,12pt,a4paper]{report}
\usepackage{nomencl}
\makenomenclature
\begin{document}
---page numbering and other things included-----
\include{symbols}
-----others---
\end{document}
symbols.tex
\chapter*{NOTATIONS}
\addcontentsline{toc}{chapter}{Notations}
\nomenclature{$G_e$}{Equivalent Shear Modulus}
\printnomenclature
Shall I use \nomenclature
while explaining the chapter. Will It give me the same results? like
\documentclass[pdftex,12pt,a4paper]{report}
\usepackage{nomencl}
\makenomenclature
\begin{document}
---page numbering and other things included-----
\include{symbols}
\include{chap3-calculate_w}
-----others---
\end{document}
symbols.tex
\chapter*{NOTATIONS}
\addcontentsline{toc}{chapter}{Notations}
\printnomenclature
chap3-calculate_w.tex
\chapter{SETTLEMENT RESPONSE OF GEOSYNTHETIC REINFORCED GRANULAR FILL SOFT SOIL}
\label{chap:W}
\section{INTRODUCTION}
In this thesis, the methodology to determine an Equivalent single layer shear modulus \nomenclature{$G_e$}{Equivalent Shear Modulus},$G_e$ value for a...etc
I am not getting the output in both these. Can someone help me with this?
{}
symbol. Thanks. Also, review your earlier questions and accept any answers that were helpful to you.makeindex <filename>.nlo -s nomencl.ist -o <filename>.els
, and then rerun LaTeX?TeXMaker
you need to define the sequence of commands used by theQuick Build
command via theConfigure Texmaker
dialog to include the above mentioned options tomakeindex
.