0

In the thesis I am writing, I have a few tables that I would like to see listed at the beginning. To do so, I use the command 

\listoftables

However, only one table is listed and all the others are not. This is still the case even after multiple compilation. I cannot tell the difference between my tables, since I used a correct caption everywhere.

What could be a possible reason for this? How can I make all the tables be listed?

I did not use the following commands:

\captionsetup[table]{list=no}
\nofiles
\includeonly
Improve this question
3
  • You should compile at least twice in your first go. And, at least twice for page numbers to be correct. After compiling twice, are the tables present in the List of Tables?
    – Werner ♦
    Mar 3, 2013 at 18:13
  • clearly that shouldn't happen given the correct markup, so markup must be incorrect somewhere, perhaps you are using \includeonly or \nofiles, or \caption isn't as correct as you hope, or something else you haven't shown is wrong, or you haven't run latex enough times or.....
    – David Carlisle
    Mar 3, 2013 at 18:14
  • Welcome to TeX.SX. A tip: If you indent lines by 4 spaces, then they're marked as a code sample. You can also highlight the code and click the "code" button ({}) or select your code and hit Ctrl+K.
    – Claudio Fiandrino
    Mar 3, 2013 at 18:43

1 Answer 1

Reset to default
1

The answer was that the rest of the tables were after the \end{document} command…

Thank you for your help anyway.

Improve this answer

Not the answer you're looking for? Browse other questions tagged .