0

This question already has an answer here:

I need to compile file using psfrag ans eps figure. I use texworks on windows and I have read that there are problems with pdflatex and I should go the latex->dvi->ps way but all I have found so far is not at all understandable for me... could you help me please? Thanks by advance :)

marked as duplicate by Joseph Wright Jan 12 '14 at 14:25

This question has been asked before and already has an answer. If those answers do not fully address your question, please ask a new question.

  • It seems that TexWorks doesn't want to hear anything about latex… The only thing I see is to use another editor, like TexMaker, TexStudio or TexnicCenter, which take latex into consideration. Or maybe try xelatex with TexWorks, as xelatex first produces a dvi file before converting to pdf. – Bernard Jan 12 '14 at 13:58
  • Thanks for your reply! Unfortunately Xelatex reply is : ! Undefined control sequence. \pfg@hidestart ...unt@ by\@ne \repeat \Gin@PS@raw {/PSfrag where{pop\pfg@ \t... – GuestTex Jan 12 '14 at 14:03
  • Yes, and it doesn't work with psfragx either, as results from this discussion: tex.stackexchange.com/questions/63258/… So there remains the possibilty of installing another editor… – Bernard Jan 12 '14 at 14:12
  • Does tex.stackexchange.com/questions/85417/… help? TeXworks is focussed on a PDF-based route but will work with a toolchain for DVI-based compilation: you just have to do a little set up. – Joseph Wright Jan 12 '14 at 14:12
  • OK, I'll dupe to that then – Joseph Wright Jan 12 '14 at 14:24

Browse other questions tagged or ask your own question.