I have PDF that I am printing as a booklet using the following code:


How can I increase the inner margins of so that I can bind it properly?

  • 1
    \usepackage[lmargin=2cm,tmargin=2cm,rmargin=2cm,bmargin=2cm]{geometry} perhaps? – user31729 Apr 6 '15 at 21:13
  • @ChristianHupfer But I want to change just the inner margin (which is left or right depending on the page) – Hernan Apr 6 '15 at 21:17
  • 1
    pdfpages has options for this. I'm not sure whether geometry will work in this case. (Perhaps it will.) – cfr Apr 7 '15 at 12:41

As @Christian Hupfer suggested, you should pass the margin options to geometry package. Specifically, setting inner should do the trick. To quote from its documentation:

If margins on verso pages are swapped by twoside option, margins specified by left and right options are used for the inside and outside margins respectively. inner and outer are aliases of left and right respectively.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.