0

I have a huge figure, approx 2000 pixels width and 9000 pixels height (approx -- just to give an idea).

\begin{figure}[!htb]
    \centering
    \ContinuedFloat
    \includegraphics[scale = 0.2]{model.png}
\end{figure}
\FloatBarrier

The problem is, even with a scale of 0.2, it is not fitting on the page. I can go further, and scale it down even more, but if I do so, it'll become totally unreadable.

Since it doesn't fit in the page, the bottom part of the image is cut-off. Is there any way I can spread my image across two pages so that no info is lost?

I looked at posts like this, but they deal with more than one figures (sub-figures), while I only have a single image. Any help would be great. Thanks...

4
  • 2
    if it is a big figure don't use [!htb] !!! as the main effect of that is to omit p so prevent it being on a page with just figures, and specifying latex had to leave room for text on the page as well. You want exactly the opposite [p]. Just split the image in two using an image editor then two [p] figures will appear on adjacent pages. Commented May 30, 2020 at 21:30
  • 4
    You can use this post to split the image. Presumably a breakable tcolorbox will also work. Or just use the trimclip package to do appropriate clips.
    – user194703
    Commented May 30, 2020 at 21:31
  • @Schrödinger'scat got it, thank you :) Commented May 30, 2020 at 21:38
  • @DavidCarlisle I didn't know about it.Thanks :) Commented May 30, 2020 at 21:38

0

You must log in to answer this question.

Browse other questions tagged .