# Page numbering and the correct place of appendix sections

I want to add an appendix with continuous page numbering to my thesis, which is a report document class. I have tried doing as follows, but all of the sections are shown in the first page of the appendix and then the tables and figures appear. I want each title to be for a certain group of table/figures, however.

\appendix
\chapter{Appendix}


and like this in the report itself:

So mainly two questions:

1. How to have continuous page numbering for the appendix?
2. How to put each section of the appendix (A.1,A.2,...) on the corresponding page with relevant table and figures?
• Welcome to TeX.SX! Please help us help you and add a minimal working example (MWE) that illustrates your problem. Reproducing the problem and finding out what the issue is will be much easier when we see compilable code, starting with \documentclass{…} and ending with \end{document}. – Nepumuk Dec 8 '20 at 20:24

You have not shown what you have done. You have to enter the tables and figures for each section after the \section command. Perhaps they are too large for the page in which case put \clearpage before the next \section.
Normally the bibliography will not make changes to the page numbering nor will the \appendix macro so I have no idea why your appendix page numbering is reset to start at 1 following your bibliography.
• It puts the sections in the right place but the tables start at the end of the page where section name is. I am also using \usepackage{flafter} so the tables/figures will be after the reference points. – Agi Dec 8 '20 at 19:23