5k views

### How can I force TikZ pin angle?

I'm trying to draw a resultant force diagram like so: \documentclass{article} \usepackage{tikz} \begin{document} \begin{tikzpicture} \draw (0,0) -- (90:2.7) -- ++ (-13:12) node[shape=...
541 views

### swap a label to inner corner

I have below code section, the label "B" is displayed at the outside of the corner, how can we swap it to the inner corner? or any other good suggestion to label it? \documentclass{standalone} \...
5k views

### Vertical space inside a TikZ node

I am trying to insert some vertical space inside a node (So it will be filled later). \node [draw,rounded corners,minimum height=5cm] (node1) {\underline{Case 1}}; This is giving this: However, I ...
2k views

### Triangle with text in it

I have an automaton in tikz and would like to have some text within a triangle of the right size. How can I do that efficiently? I have tried using a regular polygon, but I can't shrink it to the ...
41k views

### How to rotate a TikZ label

I need to place information below and to the right of a grid. I was not able to rotate the label text of a node. I ended up using \rotatebox, but is there a pure TikZ solution? \documentclass{...
1k views

### Specific tikz shape with parameters

The idea is to define several shapes useful for example in control schemes. For example a generic shape for conversion could be defined instead of creating one shape for each conversion. The code ...
4k views

I was looking for a possibility to adjust the anchor of the text of a pin. Tikz does not allow this out of the box. This question was already asked on the mailing list pgf-users@lists.sourceforge....
3k views

### Putting text at bottom of ellipse in a tikz picture

I have the following code: \documentclass[journal]{IEEEtran} \usepackage{tikz} \usetikzlibrary{shapes,backgrounds} \begin{figure}[ht] \begin{tikzpicture} \node[rounded corners, draw, fill=gray!20 ,...
497 views

### Circuit Node with Text near Input and Output

I'd like to draw a user defined a simple node shape in combination with the circuit library. The node has one input and one output. I'd like to put text inside the node shape near the input and output....
153 views

### Not able to align nodes properly

I have the following code: \documentclass[11pt]{article} \usepackage[utf8]{inputenc} \usepackage{geometry} \geometry{a4paper} \usepackage{tikz} \usetikzlibrary{matrix} \usetikzlibrary{calc} \...
158 views

### Artificial displacement between a point and its coordinate using the coordinate command

What is the default separation between a point and its label when using thecoordinate command? In the following code, I plot some dots on a grid using label option and "." to typeset the dot. The dot ...
808 views

### mirror node shape

I have to draw a diagram and would like to fit it on a page, thus i have not much space. Therefore I have to "stack" some gates, however it would be beneficial if I could put the outputs of the logic ...