Episode #125 of the Stack Overflow podcast is here. We talk Tilde Club and mechanical keyboards. Listen now

Questions tagged [tikz-angles]

This tag is for the TikZ angles library.

Filter by
Sorted by
Tagged with
3
votes
1answer
315 views

How to double, or triple an angle mark's decoration with TikZ?

I would like to decorate an angle's mark in a similar way as in this picture (taken from this question): From this answer I could build this: \documentclass[a4paper,12pt]{article} \usepackage{tikz} ...
8
votes
2answers
683 views

Dimension too large error (apparently no calculation involved)

From what I have read so far, a Dimension too large! is caused by a result or an intermediate calculation that goes beyond the limit of 16384. I get this error with this document (note: the ...
5
votes
4answers
4k views

how to draw a phasor diagram (like this picture)

Hi, I would like to draw this phase diagram as in the attached picture. But some examples I see in the internet are so different (more complex) and when I choose one way to follow I don't know how to ...
3
votes
2answers
189 views

How do I mark an angle with multiple arcs?

I have been trying to find a good answer to this question (or a question to match it): I'm trying to give an angle a marking with multiple arcs in the interior, as per the pictures below. I'm not ...
3
votes
3answers
4k views

TikZ: using the angles library

I am trying to use the angles library, but I am not sure how to apply it when the nodes were specified from other methods. In the examples, the drawing of the vectors and naming of the nodes happens ...
2
votes
1answer
352 views

How can I put the angle more right than I put here? And how can I make a subtitle also?

Is it possible to adjust the angle more than I did: [ABOVE RIGHT] \draw [black, thick] (0.7,0) arc [start angle=0, end angle=110, radius=0.7cm] node [above right] {$\theta=\phi-\ang{90}$}; I'...
5
votes
1answer
921 views

Tikzpicture: Add slope angles to straight line

I am trying to add some angles between the x-axis and the red and blue line which indicate their slope. \documentclass[15pt,a4paper,headinclude, totoc]{scrartcl} \usepackage[usenames,dvipsnames]{...
2
votes
2answers
163 views

Placing a node label in a specific location

I need the \alpha_1 to be a bit close to the corner, it should be placed "nicely". I tried the following code (with various numbers in label distance/angle): \documentclass{article} \usepackage{...
2
votes
1answer
1k views

error when using tikz with quotes and angles

i want to draw some angles using tikz where i have the following code: \documentclass{article} \usepackage[ngerman]{babel} \usepackage{tikz} \usetikzlibrary{quotes,angles} \begin{...